Description
This detector can be used in all areas where heat detector is required. It is suited for fires ranging from heat to flaming fires.
It is designed to provide open area protection and to be used with most conventional fire alarm panel.
A red LED flashes every six seconds indicating that power is applied and the detector is working properly. The red LED latch on in alarm. LED will be off when a trouble condition exists indicating
that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption. The detector that initiated the alarm condition will have its red LED latched until reset by fire alarm control panel.
SPECIFICATIONS
Operating Voltage Range: 9 to 28 VDC, Non-polarized
Standby Current: ≤50µA@24VDC
Maximum Alarm Current (LED on): ≤35mA@24VDC
Operating Humidity Range: ≤95%RH(40°C±2°C) Relative Humidity, Non-condensing
Operating Temperature Range: -10°C to 50°C
Alarm type: Resettable detectors
Category: A2R (Typical temperature 62°C)
Remote LED: Only for CHD812-R.
Standard:EN54-5:2017
Remote LED:Option.
Height: 49.5 mm installed in Base
Diameter:100 mm
You May Also Like：
